Today we will see where Mi redmi 5 edl test point. Before that we will know what is the function of EDL test point.
We will now know what it is and what it is used for
EDL test Point
Inshort EDL test point means Emergency Download Mode. edl test point is usually used for phone flashing and unlocking.
EDL test Point Work Full Detail
Mobile EDL (Emergency Download) Test Point is a set of hardware pins or pads on a mobile device’s circuit board that allows the device to enter into the EDL mode for flashing or unbricking purposes. The test point can be used as an alternative method to enter EDL mode if the device’s software-based method is not working.
To use the EDL Test Point method, you need to short or connect the pins using a conductive material, such as a tweezers or a metal clip, while connecting the device to the computer via USB. This will force the device to enter into the EDL mode, and then you can use a flashing tool, such as Qualcomm Flash Image Loader (QFIL), to flash the firmware or unbrick the device.
It’s worth noting that accessing and using the EDL Test Point can be risky, and may void your device’s warranty, so it’s important to proceed with caution and do proper research before attempting it. Additionally, EDL Test Point locations can vary from device to device, so it’s essential to find the correct test point for your specific device model.
In a word, it is used to solve any software problem of the phone.
How To Connect EDL Test Point
- Locate the EDL test point on the device’s PCB. This may require disassembling the device and carefully inspecting the PCB. The test point may be labeled or unmarked, and it will typically consist of two or more exposed metal pads or pins.
- Identify the pins or wires required to connect the EDL test point to your device’s USB port. You may need to consult the device’s documentation or search online for instructions specific to your device. Some devices may require soldering or using jumper wires to make the connection.
- Connect the pins or wires to the appropriate pins on the device’s USB connector. This will typically involve connecting one wire or pin to the ground (GND) pin and another wire or pin to the data- (D-) or data+ (D+) pin. You may need to refer to a USB pinout diagram to determine the correct pins.
- Use a multimeter or continuity tester to verify that the connections are correct and that there are no short circuits or other problems.
- Once the connections are verified, you can hold down the EDL test point and turn on the device to enter EDL mode.
Note: Connecting an EDL test point can be risky and should only be attempted by experienced users with the proper tools and knowledge. Always exercise caution when working with electronic devices and follow all safety precautions.
Below is the image edl test point of Mi Redmi 5
